PSE Typhoon ja vetopituuden muuttaminen.|Välineistä ja tekniikasta|SJML keskustelufoorumi|jousimetsastys.fi

Kokeilen lyhentää Typhoonin vetopituutta tuuman verran. Manuaali kertoo sivulla 12 näin:

NO BOW PRESS OPTION

The X Technology bows do not require a bow press to relax the

strings for service.

Relax Strings for Service

1.

Loosen and remove the 4 locking tab screws (see Figure 2).

Damage may occur to the limbs at the pin holes if the locking tab

screws are not removed before fully backing out the limb bolts.

2.

Loosen the 4 limb bolt locking screws.

3.

Back limb bolts out one turn at a time alternating between all 4

limb bolts. Never have more than 2 turns differential between the limb

bolts at any time. Back the limb bolts out until they are flush with the

anchor (see Figure 2).

Tighten Strings after Service

1.

Check to make sure the all the half rounds and underlays are installed and

properly seated between the limbs. Note: It is important that the underlay is

seated properly over the pin on the half round and the pin on the pocket.

(see Figure 1).

2.

Begin tightening the limb bolts one turn at a time alternating

between all 4 limb bolts. Never allow more than two turns differential

between limb bolts at any time.

3.

Once the limbs have bottomed, the wheel attitude can be adjusted, if needed. (see

the Setting Wheel Attitude section for this procedure) and then set the poundage.

4.

Reinstall the 4 side locking tab screws and tighten the limb bolt locking screws

Onko näin ettei tämä malli tarvitse jousiprässiä?

http://www.bogensport-mv.de/up…..sguide.pdf